Our Products
Avionics Systems

Home      >      Our Products       >     Avionics  Systems     >    MIL-STD-1553B

MIL-STD-1553B Ipcore ve Test System

1553 IP Core

A designed system can be programmed as Bus controller, Remote terminal, or Bus monitor depending on the choice of the user. IP Core is designed to meet the requirements of the MIL-STD-1553B Notice2 standard.

  • Operation at a frequency of 16 MHz
  • Switching to BC, RT and BM modes according to user choice
  • Changeable remote terminal address
  • Ability to generate commands and answers by 10 message formats defined in the standard
  • Sending and receiving broadcast messages
  • Communication via redundant bus
  • Generating automatic status word response
  • Detect illegal commands
  • Sensing the mode commands specified in the standard and producing appropriate answers
    • Transmit status word
    • Initiate self-test
    • Transmitter shutdown
    • Override transmitter shutdown
    • Reset remote terminal
    • Transmit the last command
 IP Core
LUTs8176
FFs7055
DSPs0
36k BRAMs0
18k BRAMs0
IO77
  • MIL-STD-1553 Terminals
  • Sensor Interfaces
  • Flight Control Systems
  • 1553 Test Equipment

1553 Test System

The 1553 test system is used to test systems using the MIL-STD-1553 communication protocol. The test system consists of a test card and a test program. The FPGA on the test card is programmed with our 1553 IP Core, which we developed. The relevant units are tested by selecting the appropriate operating mode (BC, RT, or BM) and scenario files via the test program. 

The test system tests these units by sending the user data it receives over the ethernet interface to the units on the 1553 bus. 

  • 8 x 1553 Connector (BJ-79)
  • 5 x Information Indicator
  • 1 x Error LED Indicator
  • RJ-45 Ethernet Connector
  • On / off Switch
  • 12 VDC Power Input
  • Weight: 600 g
  • Height: 32 mm
  • Length: 200 mm
  • Depth: 108 mm